|
en | fr

Approximate time: 15 minutes

Instructions for assembling DiscoEasy200 - Page 11 - Check

Check the proper functioning of the machine components

We will check all components using test files.

Step 1

Checking stops and motors

The following file will make some simple moves. See the video on the right.

Retrieve the power supply and connect the machine to the mains.

Download the file below and put it on the SD card. Name the file "dagoma0.g" on the card otherwise the machine will not start.

Télécharger

Put the SD card in the machine and set the switch to 1 (it starts when the switch changes from 0 to 1).

If the behaviour is different from that observed, check your wiring ici.

If the wiring is good but the problem persists, go to ici.

Si les moteurs de l'axe Z sont lents, passez à la mise à jour de l'imprimante et revenez sur ces contrôles ensuites

Step 2

Control of axis movements

The following file will make some movements along the entire length of the axes. See the video on the right. When moving the X axis from top to bottom, oil the bars and threaded rods.

Download the file below and put it on the SD card. Name the file "dagoma0.g" on the card.

Télécharger

Insert the SD card into the machine and set the switch to 1.

When the movements are finished, stop the machine (switch on 0).

If the behaviour is different from that observed, check your wiring ici.

Step 3

Fan control

The following file will run the fans one after the other. The rear fan will turn on for 5 seconds and then it will turn to the front.

Download the file below and put it on the SD card. Name the file "dagoma0.g" on the card.

Télécharger

Insert the SD card into the machine and set the switch to 1.

When the movements are finished, stop the machine (switch on 0).

If the behaviour is different from that observed, check your wiring ici.

Ne perdons pas de temps pour comprendre l'utilité des ventilateurs et vérifions leur branchement, rendez-vous ici.

Step 4

Contrôle de la chauffe et de l'extrusion

The following file will heat the head to 200

It will move from left to right while it is warming up.

Once it''s on the right, it''ll be hot.

It will then pause (it will go up a little and the tray will move forward).

Introduisez du filament dans l'extrudeur jusqu'à la tête. Appuyez sur le bras pour débrider l'extrudeur et introduire le filament. Quelques torsions peuvent aider à le rentrer. (Après la mise à jour, avec l'extrudeur+, l'insertion sera automatique.)

Then press the stop. The machine will exit the filament through the nozzle. Remove it carefully - the head is hot.

Download the file below and put it on the SD card. Name the file "dagoma0.g" on the card.

Télécharger

Insert the SD card into the machine and set the switch to 1.

When the movements are finished, stop the machine (switch on 0).

If the behaviour is different from that observed, check your wiring ici.

If the wiring is good but the problem persists, go to ici.

Control: CHECK!

If you have reached this point, it is because your machine is ready to operate.

We have reached the goal, we still have to update the machine, calibrate it and you will be ready for your first print.