|
en | fr

Approximate time: 25 minutes

Instructions for assembling DiscoEasy200 - Page 8 - Assembly of the tray

Assembling the tray

We will now assemble the part that will accommodate your printing: the tray.

The prerequisites

  • 1 grappe de support plateau
  • 1 plateau
  • 1 courroie de 85cm
  • 4 vis fraisées M3x10 cruciforme (il doit en rester 1)
  • 4 écrous freins M3 (il doit en rester 1)
  • 1 tournevis cruciforme PH1 (non fourni)

Step 1

Assembling the tray supports

Détachez et nettoyez les pièces à l'aide de la spatule.

Mettez en place les écrous dans les pièces, côté caoutchouc de l'écrou vers les logements qui accueilleront les roulements

Take the large support, position the letter A towards the shortest side of the tray.

Allez à l'étape d'en dessous pour vérifier le sens.

Remove the tape that extends over the screw holes.

Screw in slightly only to hold the parts.

Répétez l'opération pour les deux autres pièces (écrous vers l'extérieur).

Step 2

Let''s check all this out.

This is the final result. Watch the direction of the elements.

Step 3

Installation on the printer

Faites monter l'axe X pour laisser passer le plateau (tourner les deux coupleurs dans le sens des aiguilles d'une montre).

Pre-position the bearings on the bars.

Take the tray with the long support towards the front (as on the video).

Place it on the bearings.

Sur un côté, alignez les roulements au milieu des pièces orange.

Press the plate to clip the bearings.

Repeat the operation on the other side.

Slide the tray along in both directions so that the assembly glides smoothly.

Tighten the plate screws (do not force them).

Make sure that it always slides after tightening. If this is not the case, slightly loosen the screws.

Step 4

Checking the perpendicularity of the base

Now that the tray is mounted, we can perform an important check.

Avancez le plateau jusqu'à la face avant.

Check that both are parallel (a few mm spacing is acceptable).

Repeat the operation on the rear side.

If this is not the case, a bar must be incorrectly pushed in (see page 7).

Step 5

Installation of the tray belt

Take the 85cm belt.

Turn the DiscoEasy200 around to access the bottom of the machine.

In this video do not hesitate to use the pause button.

Pass the end of the inscription A to B through the front tray holder (notches at the bottom of the machine).

Let it extend over the B side by about 2cm.

Slide it down to lock it.

Prenez l'autre bout et faites-le passer au dessus du premier roulement en haut de la face avant (crans vers le roulement).

Retrieve it from below and pull to remove the slack (do the same thing at each step). Beware of spins in the belt.

Pass the end between the motor pulley and the second bearing.

Pass the belt between the crossbar and the plate.

On the rear side, slide the belt under the bearing and push to pick it up above.

Pass between the bar and the tray and insert the end into the front tray holder from B to A.

Pull the belt gently to tighten it and push it down to lock it.

Bend the end and pass it through the clip to finish.

Assembling the tray: CHECK!

We''re nearing the end. Next step, the wiring.