The first step is to re-positinoner the electronic card. Screw the two retaining screws (M3-6mm)
Ensuite, passez au câblage. pour cela, suivez le guide par ici.
Finally, you can re-install the transparent protective plate by positioning the 12 anti-slip pads.
31 - anti-slip pads installation
Add 4 other pads on the new plastic parts
32 - XL set preparation
Pick the M3-6mm screws and two nuts. We will install then on 2 ears/waves of the new plate. Please be carefull the up side got got bigger holes - as shown in the video.
Please tighten those 2 screws.
33 - XL set installation
Place the tray with ears/waves back of Disco.
Slightly tighten the 4 countersunk screws 10mm, (the lock nuts have not been removed), then after you have installed and pre-screw the 4 screws you can tighten them all.
It is important to tighten properly at that time, while checking your XL tray slides properly along the Y axis (front / rear).
34 - XL magned pad installation
3 steps in this video:
1- installing the magnet pad: clean and remove dust on the fiber plate and get the magnet in position: for this you can use the 2 screws at the back of the tray as a mechanical stop. Remove the protective film and paste the magnet - it is imporant to NOT create bubbles under the magnet pad.
2- You can now place the XL flexible plate on the magnet. The two screws at the the rear of the XL tray can be used to bring it into position.
3- Paste you XL Buildgrip. Be careful not to create bubbles bellow it.
35 - first try !
Do not forget to put back your PTFE tubes into the nozzle, and you can test your tray: Here is a video demo!
36 - Screen option
You have the add-on n°1: the screen : follow this last step:
You have an extra screw to aim the new offset block of the screen on the side cover.