|
en | fr

Approximate time: 20 minutes

Instructions for assembling Magis box - box assembling

Assembling the protective box

We will assemble the protective box that will surround your 3D printer.

Preparation of the glass

The glass was delivered flat to you. We will fix the ends to form a tube.

  1. Retirez partiellement les films protecteurs de chaque face sur les deux bouts.
  2. Repliez les deux bords, entrelacez les encoches pour qu'elles se prennent les unes dans les autres. Relâchez en vous assurant que chaque encoche est bien enclenchée.
  3. Tirez de part et d'autre de la couture pour verrouiller le tout.

Tightening the glass

Pull on both sides of the seam to tighten it.

Repeat on the other side.

Preparation of the upper straps

Arrange the first 3 straps as shown in the picture.

Assembling the upper rear strap

The back of the box is represented by the seam. The bottom of the box has notches as in the video.

Stand on the side without a notch. Retrieve the upper rear strapping.

Press the box to fold it, snap the strapping into the holes provided for this purpose and release to lock it. All dewclaws must fit into the holes in the glass.

Then, take 2 rubber bands and install around the 2 rear pins.

Verification

The pin must be centered in the hole in the glass. Pull the glass to align it.

Assembling the upper front straps

Take 2 front straps. Pinch the glass to bend it in the middle of the two holes as in the video and install the first strapping. Orient it to complete the notch on the rear strap.

Take 3 rubber bands and lock the 3 available pins.

Do the same with the second strapping. This time, we''ll need four rubber bands.

Verification

Make sure you get the same as in the picture. The glass must follow the strapping well.

Preparation of the lower straps

Arrange the first 3 straps as shown in the picture.

Assembling the lower rear strap

Turn the box over to install the next strapping. Take the lower rear strap. Fold the box at the seam and place the pins in the holes.

Retrieve 2 rubber bands to lock the available pins.

Assembling the lower front straps

Take the last two straps. Pinch the glass to bend it in the middle of the two holes as in the video and install the first strapping. Orient it to complete the notch on the rear strap. Do the same with the second strapping.

Take 7 rubber bands and lock the 7 available pins.

Verification

Make sure you get the same as in the picture. The glass must follow the strapping well.

Removal of protective films

Remove the film from the glass.

Tip: You can move the glass away from the strapping to remove the remaining pieces.

Installation of the carriage

Take the carriage and 2 curved screws.

Insert the screws into the holes of the strapping.

Remove the magnetic stop.

Place the carriage to align the holes.

Then screw it in firmly with the small provided wrench.

Then take the lock and 2 countersunk screws.

Place the lock in front of the holes on the outside of the box to pinch the glass between the carriage and the lock.

Then screw it in firmly using the small wrench provided.

Installation of cable guides

Take the two cable guides.

Orient them to align them to the different shapes.

Then screw them in using the last two countersunk screws.

Assembling of the box completed