|
en | fr

Preparation

Instructions for assembling Magis and Neva box - preparation

You received your box for Magis and Neva

We will assist you in the assembly and installation of your protection for the Magis and Neva 3D printer.

In this box you found

  1. x2 guides câbles
  2. x1 fixation chariot
  3. x1 butée aimantée (aimantée au chariot)
  4. x3 pieds de Magis
  5. x1 chariot
  6. x1 sachet de vis et outils (clef de 6, clef de 2.5, 2 vis M8x20, 4 vis fraisées M3x10, 2 vis bombées M3x12, 6 patins, 20 élastiques, 2 clips imprimés)
  7. x1 rail
  8. x1 vitre de protection
  9. x1 socle en bois noir
  10. x6 cerclages (1 fixation arrière supérieure, 1 fixation arrière inférieure, 4 fixations avant)

Installation of the pads

Take the 6 skids from the small screw bag.

Under the wooden base, push 3 skids into the corners as shown on the video.

Then under each of the three feet, push in a skate.

Put the base aside, it will be used later.

Installation of the feet on the Magis

Take the 3 feet back and install them on your 3D printer.

Push the ergot back into the hole provided for this purpose.

Preparation of strapping

Remove the protective film from the parts.

Element preparation completed